Foreign media broke the iPhone 13 3D printing model: the bangs are smaller, the speaker position is changed

Many people are very concerned about the appearance of the iPhone 13, but from the current situation, Apple really wants to adjust the design.

A model diagram obtained by foreign media pointed out that the bangs of the “iPhone 13” may be greatly reduced, and the earpiece speaker of the new model will be moved to the edge of the front glass panel. Since the iPhone 12, Apple has been rumored to reduce the size of the bangs of the TrueDepth sensor on the iPhone. This rumor reappears on the “iPhone 13”.

The exposed model shows that the size of the bangs is slightly different, but in the end it looks smaller than the grooves of the current generation. The width of the bangs rose from 5.3mm to 5.35mm, while the length was reduced from 34.83mm to 26.8mm. Although the height is slightly higher, because the earpiece speaker moves up to the edge of the front glass, the overall bangs will appear narrower.

In addition, the infrared camera and light shooting illuminator on the left side of the iPhone 13 speaker will move to the middle of the bangs. The reorganized selfie camera may also move from the right side of the bangs to the left side. It is still unclear how real the simulation map is, especially considering its relatively unknown source. It may be constructed based on other recent rumors about gap changes. The data does not originate from the official design diagram. In March, rumors of narrowing the gap by trimming the speakers appeared in the form of three glass panels allegedly prepared for the “iPhone 13.”

Before that, photos of the front glass panel of the iPhone 13 appeared on the Internet. From the pictures, it can be seen that the bangs of the iPhone 13 are smaller, that is, narrower. At the same time, the earpiece position is at the top.

3D printingThe model shows that the bangs are smaller and the speaker position is changed” src=”https://www.3ddayin.net/uploads/allimg/210405/22345Q257-0.png” style=”height:auto;” />

3D printingThe model shows that the bangs are smaller and the speaker position is changed” src=”https://www.3ddayin.net/uploads/allimg/210405/22345T404-1.png” style=”height:auto;” />

3D printingThe model shows that the bangs are smaller and the speaker position is changed” src=”https://www.3ddayin.net/uploads/allimg/210405/22345W928-2.png” style=”height:auto;” />

(Editor in charge: admin)